Custom Mould Parts Ejector Institutions

Custom Mould Ejector Institutions Features:

1. Shorten mold change over time.
2. Can be put into existing molds to save time and money.
3. Hydraulic return by fixed coupling.

Custom Mould Ejector Institutions Installation Guidelines:

• Move the ejector plate to the molding position ( mold closed ).
• Move also the ejector cylinder rod to the fully retracted position. It’s important to check by hand, that the rod is fully pushed back to the fully retracted position before measuring.
• Measure the distance between the coupling and ejector cylinder rod.
• Extend the ejector cylinder rod with an extra knock-out rod of the measured length + 30mm for AAR-D-01 and 50mm for AAR-D-02.
• Move the mold ejector plates to the forward position ( mold open )
• Lock both the extra knock-out rod and the other end of the quick coupling.
• Move the mold ejector plates back to the mold closed position and make the coupling between the ejector plate and the ejector cylinder rod. Make sure that the ejector plate and ejector cylinder rod are both in the mold closed position as soon as the coupling is made, if not, adjust
• Do not use quick mold change systems.
• One set AAR for one mold only.